x-pider case front usb cable help

[scoop591]

Does anyone else use the Aspire X-pider case (picture here) . I screwed up and forgot the color coding for the front usb cables. I was swapping out the multiple plastic pin holders for a single holder for all of the pins. Well, I forgot to write down the corresponding color/labels and now i'm stuck. Could someone with this case tell me what the color coding is? The cables don't appear to follow any standard scheme. I have a picture of the original holders here. By the way, alcoholic beverages and case mods don't mix...

Thanks

 

[Rukkian]

This should be the info you need, if they are the same as my superalien.
http://www.aspireusa.net/images/atxa6sw-amd.jpg

 

[scoop591]

Unfortunately, Aspire was zero help. I emailed them with no reply and their site had diagrams, but none that matched the x-pider

 

[DerwenArtos12]

Originally posted by: Rukkian
This should be the info you need, if they are the same as my superalien.
http://www.aspireusa.net/images/atxa6sw-amd.jpg

USB is USB that should work.

Wait a minute. Those headers you are holding look like firewire not USB

 

[scoop591]

USB is USB, but not all color schemes match the red, white, green, and black standard. I'm trying to match the colors I have to the labels on the pictured headers. No, the headers are not Firewire.

 

[DerwenArtos12]

well all I can think of is to use a volt meter to determine the ground and the 5v. What colors do you have for the two data streams then?

 

[Zepper]

According to the Aspire page (perhaps you were still hung over when you went there to look), the original order of the color is black=g, yellow+d, green-d, red=5V.
.bh.