Woohoo ... Worlds Slowest XP :)

[Krueger81]

Hello,

I just finished the wire trick on my MSI K7N2-L, which I thought I would ne never be able to overclock with.

I booted up the Computer and it said 933. I was like woohooo.. It was still set at 133 FSB and 7x Multiplier. It was fairly easy to put a piece of wire in the two pin sockets. 🙂 Monster Cable Speaker WIre to be exact. I took about three strands and twisted them together. cut off about half an inch and went to town.

It boots up as Athlon XP 700MHz at 100x7 🙂 Yah. I haven't had time to tweak with it yet since I gotta get to work. But I will post back as soon as I get my PC3200 Memory from SVC. 🙂

Yah I can't wait to see FSB 200 on this board.

Phil

P.S. Oh yeah using an XP 2400+ with ThermalTake Aquarius II Watercooling Kit. (Not yet installed, See above, No Time)

 

[DAPUNISHER]

I was about to say congrats on wasting your money until I saw you do intend to push dat badboy but hard! 🙂

 

[MadRat]

You should be able to squeeze down to 300MHz if you really try.

 

[railer]

just something to do on a Saturday....

 

[Mingon]

try a mobile xp chip in a non supporting mobo - 500mhz of power!

 

[JeremiahTheGreat]

now this is my kinda thread 😛

Athlon XP 1600+ @ 697 Mhz, just beat ya hehe.

 

[Soulkeeper]

yeah but how low can you get the voltage while keeping it stable at those kinda speeds ?

i think the lowest i got my 1700+ to run on was like 1.1v
can you guys get much under 1v maybe ?

 

[Krueger81]

well I installed the Thermaltake Aquarius II and man that thing sucks. My SK7 does better on the chip at stock then the Water Kit. Either I must be doing something wrong or it just sucks.

Anyway I put the SK7 back on with a Panaflo L1A and the sucker runs nice and cool at 51C at full Load at 2040 MhZ (170FSB*12) that is with Crucial PC2100 1 Gb Ram so I will update once I receive my sammy PC3200 from SVC.

Phil

 

[MadRat]

Don't forget some motherboards with jumpers to set the FSB support sub-100MHz settings. 😉