will ram work with mobo?

[xNIKx]

mother board : http://www.newegg.com/Product/Product.asp?item=N82E16813131070
ram : http://www.newegg.com/Product/Product.asp?item=N82E16820145590


Ok on my mother board it says

Number of DDR2 Slots 4x 240pin DDR2
DDR2 Standard DDR2 800
Maximum Memory Supported 8GB
Dual Channel Supported Yes

Notice: Only DDR2-800 memory supporting JEDEC approved 1.8V operation with timings of 5-5-5 or 6-6-6 is supported on Intel Desktop Boards based on Intel 965 Express Chipsets.

This is my ram

Brand CORSAIR
Series XMS2
Model TWIN2X2048-6400
Type 240-Pin DDR2 SDRAM

Capacity 2GB (2 x 1GB)
Speed DDR2 800 (PC2 6400)
Cas Latency 5
Timing 5-5-5-12
Voltage 1.9V
ECC No
Buffered/Registered Unbuffered
Heat Spreader Yes

 

[xNIKx]

bump

 

[Peter]

Dude ...

"only 1.8V operation" vs "Voltage 1.9V". Too difficult to figure out a "No"? 😉

 

[Squeegemiester]

Boot with a stick of 1.8V RAM - up your memory voltage setting. Shut down, install the Corsair - boot up - rock and roll.

 

[xNIKx]

i dont want to buy another memory card to booty up and then return it.

ill probably get this ram since its theres only 3 and the kingston is too much and the other doesnt have any reviews.
http://www.newegg.com/Product/Product.asp?Item=N82E16820211066
only problem is i didnt have a very good expeirence with Adata. After 30 days (cant return after 30 days) it died, i ramed and now my new one is working good but im always worried it will die.

Would this work?
http://www.newegg.com/Product/Product.asp?Item=N82E16820231098

 

[deathwalker]

Almost certainly will work..........it will just boot at a lower timing like 5-5-5-18 vs. 5-5-5-12. Upon boot enter bios kick up the RAM voltage a couple of tenths to like 1.9 or 2.0 and it will be fine.