Will i break my PC360s by using the xonar STX amp?

Discussion in 'Audio/Video & Home Theater' started by Maximilian, Nov 22, 2012.

  1. Maximilian

    Maximilian Lifer

    Joined:
    Feb 8, 2004
    Messages:
    12,592
    Likes Received:
    5
    They are 50 ohm headphones, the +12db setting on the xonar control says its for 64~300 ohm headphones. Will it break them if i use it for an extended time on these pc360's? They dont sound like they are distorting or anything.
     
  2. Loading...

    Similar Threads - break PC360s xonar Forum Date
    Headphone amps: is my Xonar U7 not doing justice to music? Audio/Video & Home Theater Dec 1, 2015
    $12/mo = Hulu without ad breaks Audio/Video & Home Theater Sep 2, 2015
    Suggest me a good HTPC remote that won't break the bank (MCE + universal) Audio/Video & Home Theater Jan 2, 2015
    Plasma comes tomorrow, read me up on break in Audio/Video & Home Theater Nov 4, 2010
    In wall speakers (5 speakers) that don't break the bank? Audio/Video & Home Theater Oct 22, 2010

  3. sdifox

    sdifox No Lifer

    Joined:
    Sep 30, 2005
    Messages:
    64,238
    Likes Received:
    343
    wikipaste

    Impedance

    Headphones are available with low or high impedance (typically measured at 1 kHz[dubious – discuss]). Low-impedance headphones are in the range 16 to 32 ohms and high-impedance headphones are about 100-600 ohms.[5] As the impedance of a pair of headphones increases, more voltage but less current is required to drive it, and the loudness of the headphones for a given voltage decreases. In recent years, impedance of newer headphones has generally decreased to accommodate lower voltages available on battery powered CMOS-based portable electronics. This results in headphones that can be more efficiently driven by battery powered electronics. Consequently, newer amplifiers are based on designs with relatively low output impedance.
    The impedance of headphones is of concern because of the output limitations of amplifiers. A modern pair of headphones is driven by an amplifier, with lower impedance headphones presenting a larger load. Amplifiers are not ideal; they also have some output impedance that limits the amount of power they can provide. In order to ensure an even frequency response, adequate damping factor, and undistorted sound, an amplifier should have an output impedance less than 1/8 that of the headphones it is driving (and ideally as low as possible).[6] If output impedance is large compared to the impedance of the headphones, significantly higher distortion will be present.[7] Therefore, lower impedance headphones will tend to be louder and more efficient, but will also demand a more capable amplifier. Higher impedance headphones will be more tolerant of amplifier limitations, but will produce less volume for a given output level.
    Historically, many headphones had relatively high impedance, often over 500 ohms in order to operate well with high impedance tube amplifiers. In contrast, modern transistor amplifiers can have very low output impedance, enabling lower impedance headphones. Unfortunately, this means that older audio amplifiers or stereos often produce poor quality output on some modern, low impedance headphones. In this case, an external headphone amplifier may be beneficial.


    short answer. You should be fine.