Will a Swiftech MC462A fit an EPoX 8K7A+?

[J3anyus]

Probably a dumb question, but I just wanted to check before I go out and buy these. Anyone here running a Swiftech MC462A on an EPoX 8K7A(+)? Any problems with it? Thanks.

J3

 

[Cosmo3]

It will fit without any problems. It is a little close where the standoffs bolt to the motherboard but use a fiber washer under each stud and all will work well. Running at 1507 and it only runs about 38C while surfing the net.

 

[Insane3D]

Also, be very careful, one of the standoff posts is very close to a surface mounted resisitor on the bottom of the board. The nylon nut will sit right up against it. I didn't realize the post and nylon nut was turning on one of my 8K7A+'s and the nut took the SMR right off the board...dead board. Just don't rush...