• We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.

Wierd nForce2 Problem

H

Harish

Member
My config is
Ahtlon XP 1600+
MSI KG7N2-L
DDR PC2100 Crucial 256 MB - 32MB (for shared VGA)
20GB IBM 75GXP
Pioneer A05 drive
Pioneer 120D drive

My issue is that when I installed my two new drives, I went into device properties to make sure that DMA was enabled correctly. The problem is that I do not have the IDE Primany and Secondary drivers showing up on this computer. I just have a driver called 'nForce IDE driver' The drives are dubbed as SCSI at the end. Obviously they are all IDE drives.

Not quite sure whats going on?

ANy ideas?


 
Re-run the driver installation pack, but answer No when it asks if it should install the SW IDE driver, and your drives will be back to being listed as IDE again.
 
You must log in or register to reply here.
Back
Top