Which of these for PSU cables?

[AgaBoogaBoo]

Well, I want to organize the cables in my case a little more and one way I think it using some of those wraps for the cable which helps them occupy less space by keeping them a bit more tightly held together.

I've seen heatshrink tubing, here, that has been used before.

But I also see this stuff.

They also havethis stuff at the same site too.

I really don't know what to use and the advantages/disadvantages to each of them and how they end up looking. I also need to know which ones are easiest to install or how long each takes. I don't mind if it takes long to do, as long as its not very hard. Also, doing this doesn't really pose any risk to my PSU or hardware, does it? I would think not but assuming with hardware can be tricky...

 

[shootinyou]

I've used the FLEXO PET Sleeving, very nice & clean looking. However you'll need to remove wires from connectors in
order to install. There are tools to remove wires from the 4 pin power connectors, but you'll also need male or female ends if you intend to sleeve all the power wires, and then there are the 3 pin, 4 pin atx 12v and the 20 pin MB connector. Not the easiest to install, and the possibility of mixing wires when installing them back into the connectors.

The FLEXO Wrap PET IMO, would without a dout be the easiest to install, you aren't removing wires from connectors. But I've not used it personally.