• We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.

Which is faster?

Since the 2T command rate will give you a bandwidth hit to begin with, I'd say you'd be better off at 2.6GHz @ 216MHz.
 
Shouldnt there be another divider in there somewhere? I'm running my A64 @ 2.7GHZ and RAM at 200mhz.

As for your question, I would definately say that you should run 2.6/216. OCing the RAM above 200mhz is going to be pretty useless unless you have tight timings as well, but if you go under 200mhz then your sysytem is gonna be starved off bandwidth.

My $0.02
 
Run some benchmarks.
I remember my sempron taking a hit when i had to increase the memory divider to lower mem clock and get a higher cpu overclock. Forgot where but i think it was around 2.3 or 2.4.

My memory was running under 200mhz and my prime95 benchmark times actually increased instead of decreasing from the extra cpu overclock.
 
Since we are only talking about 100 Mhz for the cpu clock, I would go with the higher mem as long as the latencies were the same.
 
You must log in or register to reply here.

TRENDING THREADS

Back
Top