What settings to try when Overclocking 700e + CUSL2 to 1 GHz?

[Valvoline6]

I upped the FSB to 133 and am running very stable at 933mHz with little or no temp increase according to asus probe. I think I can take this baby to a gig. I'm not sure what settings I should try next (running in jumper free mode) that might be stable and get me to a gig. Thank you!

 

[pancho619]

Did you try going here. Click on cpu database, choose your cpu and they'll list successful o/c setups. I hope this helps.

-- pancho619

 

[SiberianTiger]

go up a few MHz at a time. i went from 133 to 136 to 138 and now 140. anything more than that requires me to do 1.8v. goal for you is 143 for that special 1 GHz

 

[Bartman39]

What voltage to make 933mhz??? But as Siberian Tiger said take it 1 or 2 mhz at a time... Also with the cooling you have now up the voltage to 1.85 (max) and move up the mhz slowly till you reach your max then try lowering the voltage and keep checking stability...


P3 700e @1000 or 1050mhz 1.65 PAL35T w/Delta
CUSL2 1001.a
Geforce 2 GTS 64meg 240/410


uh #3 is now #2

 

[Valvoline6]

Thanks guys. I run 933 at 1.7 v. I need to try booting at 1.65 again, haven't tried it since I updated the BIOS. There seems to be no difference in temp running at 700 or 933. I noticed in the manual on page 23 it shows an External Frequency Table. 7 of the settings are in bold print, but there is no explanation as to why they are bold. Anyone know?

 

[night181]

Damn, I cant get my 700e on the asus board to go above 115 bus speed, what am i doing wrong

 

[MaJik]

night yea i know lots of people that have 700e on CUSL2's and can't get even 900 at any voltage.. i guess there are bad ones..