Originally posted by: spigot
It would work well as far as increasing the efficiency of your fridge and freezer, especially if the water was below room temp. But, if you're not drawing any hot water, and the flow stop while your fridge is running, it's just going to continue to heat the water around the condenser until you fridge stops working...you'd have to have continuous flow.
This could still cause the compressor to overheat. The water and piping would essentially act as insulators by forming a thermal boundary layer and preventing the same degree of natural convection away from the compressor, significantly decreasing the heat transfer rate and increasing the temperature at the compressor.Originally posted by: jagec
Your fridge is normally surrounded by air, which is a far worse conductor than water. If there is no flow in the water pipes, the water will warm up, which will warm the (presumably metal) pipes in which it's contained, which will then discharge that heat to the air. Unless you're wrapping the entire thing in styrofoam (and maybe not even then), you are NOT going to blow your fridge out.
