Vtek TI 200 TV/OUT probs...

Neojin

Junior Member
Feb 27, 2002
10
0
0
My system specs are listed below. I have the 23.x det drivers and i've had no probs with them so far. (even tryed last Cert Drivers and still get same prob)

I checked my Refrest rate (because I know this can be a prob) its 60mhz, so theres no prob there.

What I get, is the screen adjusting, and Windows detecting the TV out (so obviously it works) However, the screen just flickers in red and green colors. I can see a slight image of the desktop, but that is it.

Are there any issues with WinXP and TV out?

Honestly, I had a Geforce 2 Ultra (which btw is an amazing card, and im still not sure how much better my G3 is, i havent done benchs...I do notice a 20 FPS increase in 1600x res now hehe) though, I can not remember if i ever ran in on WinXP or not...it ran fine on ME.

Any ideas? need any other info? I've talked with Visiontek CS, they gave me some suggestions, basicaly only lower refresh rate and use Cert drivers, both of which I tryed. I hate sending the card back since it works, and its in there, and...well im lazy, lol. I usualy do not use TV out too much, but since I have the feature, I would like to be able to use it ya know.
 

Neojin

Junior Member
Feb 27, 2002
10
0
0
*bump*

Guess card is bad eh? No ideas? I think i'm sending the card back anyways, something must be up...shiney stuff that used to be shiney with my G2 Ultra isnt anymore...the G3 is faster, but its not looking as good.
 

BillZad

Junior Member
Feb 28, 2002
6
0
0
I also have the GF3 ti 200 by Visiontek place the monitor to optimal not
60 hrz that might help