Voltage readings with IT8728F

[combust3r]

I've tried a bunch of utilities for hardware monitoring and none so far was even close of reading voltages correctly. I'm not talking about +/- 0.1V, I'm talking about 4.2V where 12V should be HWINFO32 is the closest of them all but misses 3.3V (it shows 2.4V), while other readings are "close" to say at best.

Is this the BIOS fault, or the util's need to update to support IT8728F and Sandy Bridge ? Does anyone suffer from the same problem and have the same Super I/O chip ? Owners of P67/H67 GA boards ?

Thnx.

 

[_Mumak_]

This should be already fixed in HWiNFO32 latest Beta. Those boards have been quite new so it took some time to figure out how the sensors are connected there.

 

[combust3r]

Thanx for your reply Mumak. I still have the same problem with the latest beta (3.69-1149). I've just measured voltages with multimeter and it reads:

12V (mm: 12.44 ; hwinfo: 12.270)
3.3V (mm: 3.36 ; hwinfo: 2.493)

I've sent you an email with log/debug info and any other info that I thought it would be usefull.