Vantec FCE 62540D

Gunnyhwy1

Member
Mar 16, 2001
31
0
0
Anyone have any experience with Vantec FCE 62540D. Building a 1.2 TBird 266 w/KT7A/ Sparkle 350 w ps. I see where they may be a bit noisy but does the performance outweigh the noise? Any other experiences with this setup?
 

shaft103

Junior Member
Jan 26, 2001
12
0
0
I am currently using the Vantec FCE 62540D on my 1ghz TBird @ 1.296. It has to be the easiest to install of any heatsink I have ever had experience with. The only drawback is the noise of the delta fan but I can live with it. My temps are about 26 C idle and 44 C under load! Hope that helps!

Shaft
 

lapdog

Senior member
Jan 31, 2001
248
0
0
can it be used one fan header one Abit board kt7a or must you use a 4pin converter?
 

Gunnyhwy1

Member
Mar 16, 2001
31
0
0
Thanks for the reply! I have heard it's a bit noisy but if I can keep the temps down like yours I stomach a little noise.

Thanks


 

johneetrash

Diamond Member
Jan 3, 2001
3,791
0
0


<< Thanks for the reply! I have heard it's a bit noisy but if I can keep the temps down like yours I stomach a little noise. >>



hopefully :) im already regretting my purchase of this hsf :)
 

shaft103

Junior Member
Jan 26, 2001
12
0
0
Lapdog, Yeah it can be used on the fan header on the abit board. I have it plugged into the fan header on my KT7A and I have had no problems. The KT7A is one of the few boards that does put out enough power through the headers.

Shaft