crab
Diamond Member
I'm using a SanDisk Imagemate II USB to read my 128 & 16mb CF cards from my Canon D30...
Everytime I try to transfer large amounts of data, the reader removes itself, then immediately installs again. I'll be viewing the pics when I hear the two "kerdunk" type sounds, the window closes, then it adds itself again. I've tried the reader in two seperate computers, both worked fine. I reinstalled all USB drivers, the VIA USB filter is installed, flashed the BIOS, tried changing ports. Device manager says bandwidth used on controller #1 is 23%, #2 is 10%. "Root hub" #1 power usage is 100mA used out of the allotted 500mA, #2 is 150/500mA. There is no USB hub connected. I've noticed no problems on my other USB devices.
What the hell am I missing here?
I'm using an Enermax 350w PS.
Rig is N983CC
|
|
V
Everytime I try to transfer large amounts of data, the reader removes itself, then immediately installs again. I'll be viewing the pics when I hear the two "kerdunk" type sounds, the window closes, then it adds itself again. I've tried the reader in two seperate computers, both worked fine. I reinstalled all USB drivers, the VIA USB filter is installed, flashed the BIOS, tried changing ports. Device manager says bandwidth used on controller #1 is 23%, #2 is 10%. "Root hub" #1 power usage is 100mA used out of the allotted 500mA, #2 is 150/500mA. There is no USB hub connected. I've noticed no problems on my other USB devices.
What the hell am I missing here?
I'm using an Enermax 350w PS.
Rig is N983CC
|
|
V
