Unique window for the 1030 cases

[xXgambitXx]

i picked up this window kit from Frozen the other day, it has a curve in it for the Antec 1030 cases, the ones with that have this type of door, and i was wondering if anyone else has this window ? the main problem i'm having is figuring out where to make the cut at. it comes pretty close to the handle and i want to make sure that there is enough room for the molding around the side. so if anyone else has it, i'd appreciate a picture of the area around the handle, or just any suggestions. thanks. -ALAN

 

[Scootin159]

you should be able to just set the window on the side door & make sure it will fit. Then just trace the window onto your side door panel & cut out.

 

[Computerfix]

Hey Scootin159 - love that "I hate it when that happens link". Needed a good laugh today!! Had to put that one in my favorites!!!! Thanks for the laugh and good luck xXgambitXx on your case mod!!

Russ

 

[Undeniable]

make sure you use a washer when tracing that biznatch! Otherwise, it wont fit with that molding.....lay the washer flat on the case side against the window edge and trace it all around.........

 

[Scootin159]

<< make sure you use a washer when tracing that biznatch! Otherwise, it wont fit with that molding.....lay the washer flat on the case side against the window edge and trace it all around......... >>



Even though I'm not doing this, I think it would be good for you to point out what size washer to use for this? I imagine you want one where the wall of the washer is the same width as the middle part of the molding, right?

 

[SupermanCK]

the washer should come with your window kit...or at least most of them should come with the kit you buy