twinview clone mode grayed out in nVIEW. how do i enable it?

[angmang]

twinview clone mode grayed out under the nVIEW. how do i enable it?
i got a msi gf4 4200 tv out
i need it enabled to get tv out workin...
tried manufacture drivers aswell as normal dets

 

[PHiuR]

where you select the 2nd monitor... disable that monitor then go in and select clone.
that might work

 

[angmang]

ok so after reasearchin, i think i have to actualyl plug in the tv first for me to ungray it, then enable it
but once enabled, do i have to keep doin that? cuz i want to move my comp to my tv (other floor) and i dont want to drag my monitor as well to enable it.
so can i enable it, then just whenever i want to just plug it in to my tv (without the monitor) and it will work?

my tv is on the 2nd floor so its kinda weird to trial and error, i just wanna figure it out before i haul all my equipment again.

UPDATE:

ok well im working with my tv beside me and plug in and the clone is still grayed out................

 

[angmang]

ok when you said where u select the monitors...
well i see the picture of how it looks like and where it is, BUT i dont have it, i just have 1 monitor on there