Trouble OCing Celery 600 cCo on BH6

Woz

Senior member
Feb 26, 2000
374
0
0
Alright now, this is damn frustrating and I am hoping for some good advice. I have a new cCo Celeron 600 on an Abit Slotket III with retail HSF on an Abit BH6 rev 1.01 flashed with newest "SS" BIOS. It will run fine on 66, 75 or 83 FSB, but I only get a black screen at 100 FSB. I have adjusted voltage and no difference. Temp cannot be an issue as this is a cold winter room and the HSF is cool to touch. At 100, the system powers and sometimes I get the video card bios, but then nothing, just black. Other times, just black and the monitor doesn't even get a signal.

Now, the odd thing is, the old CPU was a Celly 300A. I had the same results when I OCed it and ended up settling for 83 FSB.

Awaiting advice.........

:frown:
 

KR

Senior member
Oct 9, 1999
324
0
0
It could be that your memory is not handling the 100MHZ bus speed. Try setting the memory timing to 333 and set the AGP to 2/3(if you haven't already). Most PC66 will run at 100MHZ with more forgiving timing selected. Most AGP graphics cards will NOT handle bus speeds of over 83MHZ so if you have not set the AGP divider to 2/3 it may be that your AGP speed/graphics card is the problem.
 

NeoSolo

Senior member
Feb 20, 2000
638
0
0
could be retail hs&f.
maybe slocket.. some people have better luck with MSI slocket.
I had smiliar problem. I got golden orb and it fix the problem.
then again that is just my case..
good luck.

mine is at 633@950 1.85v..