After re-reading Anand's article on moving to 133fsb I tried to connect the first bridge on L6 of my 750 duron in an attempt to lower it to 700 so I could run at 133fsb. The cpu will run once switched on but will not boot, the monitor stays off.
I removed the conductive paste on the L6 and it runs as per usual at 750. I've tried this several times, checking that the bios is on default multiplier before making the change but to no avail.
Has anyone had the same results or know what the problem could be? Your help is appreciated
I removed the conductive paste on the L6 and it runs as per usual at 750. I've tried this several times, checking that the bios is on default multiplier before making the change but to no avail.
Has anyone had the same results or know what the problem could be? Your help is appreciated
Facebook
Twitter