Tribewerk TK-122 fan mounting

[H20cooled]

So I just ordered 9 of the TK-122 fans (Medium Speed) and 3 feser 360 rads. So the three rads will be mounting to the front of my Mountain Mods case is it better to run these fans as a push or a pull configuration? Cause I am sure as hell not running them as push/pull. 9 of them already cost enough $$$, 18 is just not going to happen.

 

[aigomorla]

Is it too late to cancel the order and get other fans?

The tribeworks, are... expensive... and thats about it... expensive...

 

[H20cooled]

Is it too late to cancel the order and get other fans?

The tribeworks, are... expensive... and thats about it... expensive...

Well I was able to get the fans for a decent price, but since the case is clear and they will be mounted in the front where they are very visable I wanted a fan that would not be LOUD but also a decent amount of air. Since these are clear I think they will fit well with the overall look of the case. I tried to find a clear smoke colored fan but no luck and all the fans I normally would use are just flat black and would look like crap. I figured since I spent $500 on the case why not spend a little extra on the fans.

I was just going to get 18 of the coolermaster red LED fans and do a push pull as I could get the fans for $9 each, but the DB is alot higher then the 19db they list and no off switch for the LED's.

Also the Triebwerk cabling link will make it so I do not need to bust out the soldering iron to keep the fan cabling under control.

So with all that said I still have my question, do they work better in a push or pull setup.

 

[aigomorla]

on a feser rad, and with that fan, id go with pull.