TPU enabled and DRAM frequency

[jvanvuren]

As an experiment, I have flipped the TPU switch to enabled on my P8Z77-V Deluxe board. My system seem to be working normally. Now I notice, in Task Manager, that my DRAM frequency (8GB in two 4GB sticks) has been downgraded to 1333MHz from the previous 1600MHz. Should I crank it back up to 1600MHz in the BIOS, if possible, or leave well alone?

I'm running Windows 8 Pro x64 under UEFI mode on an SSD.

Thanks for any advice.

 

[bigcid10]

When you did that, it defaulted the
Clock speeds part of your bios
That happened to me also

 

[BrightCandle]

That TPU switch is evil! It messes with your frequencies and in general its to be avoided. I found the same thing out about the EPU as well, that thing causes major performance problems. Just disable all that rubbish and go about setting up your PC properly.