Ok going to continue cleaning the wires (I know it's messy) but I want to check if the BIOS will run first. I have a few more questions.
Picture Below - There is a few of these connectors, one was connected to my exhaust fan until I removed it. These came with the case. I noticed another one near another fan location. Are these wired through the case to power my fans?
ALSO I've noticed my my 3 socket fan connections aren't used. Are all the fans powered by my System Panel Connector?
* I did connect my H60 to a 3-pin connector and the radiator to my 4-pin CPU_FAN as directed.
Pictured Below - This connector came with the case. I have a HDD docking on the roof of my case. I was wondering if this had anything to do with that. I also had a SATA cable, which I've already connected so I can't figure out what this connector is or where it's supposed to go.
Additional info: My case is a NZXT H2 Classic Silent Chassis
This next question is about fan flow. I have 2 fans blowing in from the front. My PSU fan is turned down towards the ground. I removed the exhaust fan to add the H60. There is another one of the connection pieces from question one located near the bottom of the case. (Pictured Below) If it does indeed power the fan's, I was going to install the fan on the bottom. With the PSU next to it sucking from the bottom. And two fans in front of it blowing inward. Intaking air from the installed fan would really be the smartest thing to do, correct?
*** I promise! I'm going to clean those wires up before I shut the panels on this bad boy. I didn't spend that much money on a PC and attempt to build my own PC to have it look that shitty. I just want to make sure she runs first and then I'll clean her up.