• We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.

Temperature worries.

F

flamingsnoman

Member
I ran prime95 last night and when i checked my temperatures with MBM this morning, the high temperatures were through the roof! 40ºC case and 63ºC cpu. i raised the fsb by only 3-5 mhz to bring my p4 2.8 to 3.06. also, i swapped the stock heatsink with a slk-800u. i'm usin as3 as interface. is it high because the as3 hasnt set yet? or what else might be the problem? thank you for reading!
 
did u run prime95 after installing the SLK800 and AS3? Does your thermalright even have a fan on it? is 63degrees the temp of the cpu while still running prim95 or after you finished, shut down ur pc, waited 30min then restarted?

edit: 63 should be ok for ur pc after a nights work. the spec temp limit is 75. it only becomes a problem when your cpu is idling at 63degrees for a very long time
 
yes, i ran prime95 after installing my HSF. i have a 80mm coolermaster rifle bearing fan on it for sound reasons....
i idle at about 42ºC. the reason why im iono....worried(?) is that this temp is about 10ºF higher than my stock heatsink! 😕 im guessing becuz the SLK doesnt touch the whole surface of the heat-spreading thing on the cpu.




nope, im using a p4p800 non-deluxe.
 
You must log in or register to reply here.

TRENDING THREADS

Back
Top