so i want to start a slow migration over to TEC.
However i am not prepared to vasaline my entire board so i dont want super sub ambient temps. I was thinkn of using TEC's to make some sort of water chiller. Something i can play with for a few months b4 completely migrating her to sub degree temps.
So for you TEC owners, here is the question. I would have 2 loops, a TEC loop, and a chilled water loop. The chilled water would use 2 DD Hard drive waterblocks mounted with 2 TEC's, 1 on the plate.
The TEC's i was thinkn of using were the swiftech TEC blocks combos. And i havent decided on a PSU yet. I would most likely use a 120x2 radiator to cool the TEC's and the TEC loop would be chilled by the 2 custom coolers.
So does this plan seem possible? i would like some advice on this setup.
Or i wouldnt mind flames on how stupid the setup sounds. However, please keep the flames limited to the content. And the whole point is not to go below the condensation point in my case.
However i am not prepared to vasaline my entire board so i dont want super sub ambient temps. I was thinkn of using TEC's to make some sort of water chiller. Something i can play with for a few months b4 completely migrating her to sub degree temps.
So for you TEC owners, here is the question. I would have 2 loops, a TEC loop, and a chilled water loop. The chilled water would use 2 DD Hard drive waterblocks mounted with 2 TEC's, 1 on the plate.
The TEC's i was thinkn of using were the swiftech TEC blocks combos. And i havent decided on a PSU yet. I would most likely use a 120x2 radiator to cool the TEC's and the TEC loop would be chilled by the 2 custom coolers.
So does this plan seem possible? i would like some advice on this setup.
Or i wouldnt mind flames on how stupid the setup sounds. However, please keep the flames limited to the content. And the whole point is not to go below the condensation point in my case.
