- Feb 18, 2005
- 2,718
- 1
- 0
Building a workstation with an Antec mini case - the system powers on and runs fine outside the box where I assembled it and ran memtest/prime. Screwed the motherboard into the standoffs and then attempted to power on - that worked. Installed all the drives and connectors and attempted to power on, and I get nothing. No fans, no noise, no lights.
Ripped the entire right out of the box and set it up on the motherboard box again and it works great.
So, what am I looking for? Possible shorts against the metal?
Box in question is using the following:
Antec Performance TX640B
Chaintec VNF4
3700+ Sandy
2GB Corsair VS
Twin 75GB Raptors
Ripped the entire right out of the box and set it up on the motherboard box again and it works great.
So, what am I looking for? Possible shorts against the metal?
Box in question is using the following:
Antec Performance TX640B
Chaintec VNF4
3700+ Sandy
2GB Corsair VS
Twin 75GB Raptors