some tweeking

[bigKr33]

How to run dual channel mode. Please specify were and the name of the section in the bios for you dfi owners out there. The board is a Dfi ut nf4 sli-dr. The ram i'm using (geil pc3200 w/tccd) is suppose to default at 1.5-2-2-5 ddr400, but since its in single channel mode i can only get 2-3-3-5 stock. Thanks in advance

 

[RampantAndroid]

if it says 128 bit, that means dual channel....I don't have that mobo, but try the manual. I have to manually set my 1T 2-3-3-6 ram in my BFG motherboard, so you may have to do that.

 

[bigKr33]

I might try, but i know it said that it was in 64bit mode single channel.

 

[bigKr33]

So in this case i would have to change the (TCL) latency control to 1.5