Socket 370 Celeron 1100 .18 NOT Tulaitinaana. Does it overclock??

[snort1]

Does this chip overclock? Have 256MB of PC100. Can get memory cheap. Next bus speed is 112mhz.
Is 1232 mhz possible?

 

[apoppin]

The best thing to do is check the database at www.overclockers.com. I imagine it does. However, it is always the luck of the draw - some indivicual CPUs doN'T overclock very well (even though some of the same Mhz and stepping generally do).

 

[Parasitic]

Quite difficult. Coppermine's limit is about 1.2GHz, so anything higher than that may be difficult to reach. My old Celly 700 topped out @ 1176.

 

[AkumaX]

my celeron 766 coppermine topped out @ 1288

 

[Acanthus]

CuMine wont oc very well. With a good heatsink your looking at 150mhz tops. With high voltage.

 

[Herkulese]

I have a 1ghz celeron on and ABIT BH-6 rev 1.0 running at 124 FSB (1.24ghz) with no problems. It seems the later processors of this core can run in the low to mid 1.2's OK, but the closer it gets to 1.3, it becomes very questionable. The 1.1ghz will be running at 1.36ghz when running at 124 FSB and that is most likely out of the range for this core.

For example:
At 105 FSB, it would be running at 1.15ghz (High Probability of success)
At 112 FSB, it would be running at 1.23ghz (High Probability of success)

Just try bumping the FSV 1mhz at a time, with stock voltage, intil it becomes unstable, then add a bit more voltage and continue the experiment.
You will find a point where more voltage will not help stability. At that point, back off the voltage to the last stable amount and then back off the FSB a bit, to give yourself a safety factor, and run for a while to see how it will do over time.

Good Luck, and Have fun.