SN27P2 graphics card installation problem

[veneficus]

this is my first shuttle build but have so far installed everything except the grapgics card, a pci-e 7600 GT (palit). I cannot seem to get the metal end (hook) through the gap on the outside of the case (where it screws down) so i can align the card over the slot. please could anyone give any suggestions

 

[bigshooter]

Did you pull the bracket that you screw the screws into all the way up? I had to wiggle my 7900GT a little to get it in there, but it fit just fine once everything was lined up.


This post was a week ago, hopefully you got it straightened out by now.