Hey there,
I've just recieved my slk800u and will be installing it within the coming week. However, as I previewed the situation, I'm a little unsure of the procedure.
I have an Epox 8rda+ mobo, so I've definitely got the mounting holes there. However, it seems I need to screw some offsets into my mobo tray underneath these holes so that I can screw the hs down. Unfortunately, I don't have any [threaded] holes for doing so in my tray. Worse yet, I can't even drill holes on the left side because there is a gaping hole in the tray (for ventilation, I assume).
Another difficulty I foresee is that the slk800-provided offsets are considerably taller than the default mobo ones. Problem? It would seem so. Should I send back the 800u and just get an 800a? Could I simply use a small bolt on the underside of the mobo? I'm guessing that I just am not approaching this the right way, so any advice would be appreciated.
Finally, just to formalize it: those insulating cardboard washers - do they go between the screw-head and the mobo, or between the mobo and the standoffs?
Thanks for all the advice!
I've just recieved my slk800u and will be installing it within the coming week. However, as I previewed the situation, I'm a little unsure of the procedure.
I have an Epox 8rda+ mobo, so I've definitely got the mounting holes there. However, it seems I need to screw some offsets into my mobo tray underneath these holes so that I can screw the hs down. Unfortunately, I don't have any [threaded] holes for doing so in my tray. Worse yet, I can't even drill holes on the left side because there is a gaping hole in the tray (for ventilation, I assume).
Another difficulty I foresee is that the slk800-provided offsets are considerably taller than the default mobo ones. Problem? It would seem so. Should I send back the 800u and just get an 800a? Could I simply use a small bolt on the underside of the mobo? I'm guessing that I just am not approaching this the right way, so any advice would be appreciated.
Finally, just to formalize it: those insulating cardboard washers - do they go between the screw-head and the mobo, or between the mobo and the standoffs?
Thanks for all the advice!
Facebook
Twitter