SLI Issues

ebeattie

Senior member
May 22, 2005
328
0
0
Well, Im am getting thoroughly fed up with my system. see sig for specs.

Problem: When SLI is enabled, I am using the top card for my output. When I start or reboot, the top card outputs the signal, but as soon as windows is done loading and proceeds to the login screen, the top card stops sending out the signal. however the bottom card now fully outputs the display signal. when I rebbot from this, the bottom card that I am forced to use for output does not show the bios loading screens.

I assume that the second SLI card is not activated untill windows loads. but why oh why will my "main" card not display the bois load screens? I am positive I have not touched the multi display settings, in fact, I have removed, driver cleaned, and reinstalled both my forceware and nforce drivers, and I have even rolled back to the previous version forceware drivers and this issue is STILL occuring.

I have the jumpers on my LanParty set to SLI mode.

rrrrrrr!!!!!!! has anyone ever experienced this issue? where do I go to see if multi display has been enabled?