• We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.

slave HD is acting strange

A

adlianb

Member
i'm currently changing a new comp case and during my first boot up, it's detected but did not display the SMART info which it usually does. upon entering winXP, device manager detect the HD and says the device is working properly, however, in "my computer", it does not display the HD. sometimes, repeated restart is needed to fix the problem. no such problem in the past...wat went wrong? any solution??
 
check to make sure the IDE cable isn't reversed(most likely cause this has happened to me before) make sure the red stripe is on the same side as it is on the master if the master is working properly
check your jumper settings
in CMOS setup>standard setup make sure IDE0 slave is set to auto
 
You must log in or register to reply here.

TRENDING THREADS

Back
Top