Hello all! I have read great stuff about the board so..
Ok here is my problem:
Setup -
Barton 2500 (new)
Crucial 3200 2 sticks 256 (new)
WinXP
Allied 350 PS
Not sure why this is happening but....
First the board wrongly ID's the processor as an 1100. Easy fix just change the FSB to 166. OK now it says 2500. The board also seemed to wrongly ID the memory so I switched it to detect by SPD and it ID's correctly.
Here is the problem - it will not boot into windows?!? It gets 4 seconds into it goes to a error screen which I don't have enough time to read before it reboots.
Where should I start?
PS - thanks a TON in advance guys.
Ok here is my problem:
Setup -
Barton 2500 (new)
Crucial 3200 2 sticks 256 (new)
WinXP
Allied 350 PS
Not sure why this is happening but....
First the board wrongly ID's the processor as an 1100. Easy fix just change the FSB to 166. OK now it says 2500. The board also seemed to wrongly ID the memory so I switched it to detect by SPD and it ID's correctly.
Here is the problem - it will not boot into windows?!? It gets 4 seconds into it goes to a error screen which I don't have enough time to read before it reboots.
Where should I start?
PS - thanks a TON in advance guys.
