resetting cisco aironet 350 series?

[nodoubts2k]

How do you go about resetting the Cisco Aironet 350 series access point? All the documents on the site only tell how to do it with firmware versions 11.07 and up, with the boot version 1.06 and up. The access point has firmware 11.21 (i think), and boot version 1.09. I know its a shot in the dark, but if anyone can help, or knows where I can get help it would be greatly appreciated.

 

[AFB]

I have no idea, but is there a reset button? Do you have the manual?
Cisco's site is wonderful Text

 

[nodoubts2k]

I have already looked at that site, and I have newer firmware than the ones on that page.

 

[AFB]

You notice how it says and newer.

 

[ktwebb]

You can do it a couple of ways. There is an option in the CLI to default the AP, or you could flash it. Doesn't matter if it's the same firmware. Flash it anyway. It will default the AP. Overkill. You can do it from the prompt. I imagine you could do it from the web interface as well. I just never used it much.

 

[nodoubts2k]

I cant get into the prompt, it asks me for the username and password. It isnt set to get the IP from the DHCP server.

 

[ktwebb]

Ouch. We were always told by Cisco we'd have to send it in if we lost the password. Perhaps there is a hack but the GUI will want a password as well I believe. Do you know what the IP is and if so have you tried to login to the browser admin interface?

 

[ktwebb]

Double post.

 

[nodoubts2k]

when it reboots i think it shows the IP that it's supposed to respond to. I'll try and get in through the web interface.

 

[SaigonK]

Ok one question is this VXWorks of Cisco IOS? It makes big difference on how you intend to reset it.
i just did an AP350 but it was IOS based...