• We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.

Removing cable from a patch panel

W

WobbleWobble

Diamond Member
What's the proper way to remove punched down cable from a patch panel? Do you just pull the cable out or do you need a special tool?

I do have a simple impact punch down tool.

Thanks!
 
Just pull it out. If you're planning on using that same port on the patch panel again, check to make sure there is no wire casing left behind and obstructing where the conductors need to get punched down.
 
The small hook tool is called a "spudger."

http://en.wikipedia.org/wiki/Spudger

You have to be very careful pulling the wires out, and using needle nose pliers or (ideally, a spudger) makes it easier to pull the wires straight up in the groove, reducing the chances of bending the insulation displacing blades. If you screw up the alignment of the blades, you risk a flaky connection (translates to potentially hours of gut-wrenching intermittent problems).

Also remember to use the "low" punch setting. Most modern panels and punch components do not handle the "high" punch power settings well... especially if your a "serial puncher " (three or four punches per connection ... bang, bang, bang, bang ... all on the same terminal).

FWIW
 
Thanks for the answers guys.

And good tip on the low punch setting. Mine is adjustable and I couldn't find any references on which setting I should use.
 
ScottMac said:
The small hook tool is called a "spudger."

http://en.wikipedia.org/wiki/Spudger

You have to be very careful pulling the wires out, and using needle nose pliers or (ideally, a spudger) makes it easier to pull the wires straight up in the groove, reducing the chances of bending the insulation displacing blades. If you screw up the alignment of the blades, you risk a flaky connection (translates to potentially hours of gut-wrenching intermittent problems).

Also remember to use the "low" punch setting. Most modern panels and punch components do not handle the "high" punch power settings well... especially if your a "serial puncher " (three or four punches per connection ... bang, bang, bang, bang ... all on the same terminal).

FWIW
Click to expand...

Thanks mac, never knew what they were called but have been using them for a decade or more
 
You must log in or register to reply here.

TRENDING THREADS

Back
Top