Hello, I virtualized my old PC WinXP to VMware worksation v7.
I made tib image using Acronis 9.5 and then using VMware vCenter Converter Standalone Client I converted the tib to the VMWare maschine.
I then removed the old hardware using this guide
http://itknowledgeexchange.techtarg...removing-old-hardware-after-a-p2v-conversion/
But I get this error:
Found New Hardware - "your hardware is installed but might not work properly until you reboot".... This is followed by another pop-up box entitled:
System Setting Change, with the message: "Windows has finished installing new devices. The software that supports your device requires that you restart your computer. You must restart your computer before the new setting will take effect".
After I reboot the red X is shown, but every time I reboot the Found New Hardware is shown again !
I made tib image using Acronis 9.5 and then using VMware vCenter Converter Standalone Client I converted the tib to the VMWare maschine.
I then removed the old hardware using this guide
http://itknowledgeexchange.techtarg...removing-old-hardware-after-a-p2v-conversion/
But I get this error:
Found New Hardware - "your hardware is installed but might not work properly until you reboot".... This is followed by another pop-up box entitled:
System Setting Change, with the message: "Windows has finished installing new devices. The software that supports your device requires that you restart your computer. You must restart your computer before the new setting will take effect".
After I reboot the red X is shown, but every time I reboot the Found New Hardware is shown again !
Last edited:
Facebook
Twitter