Hello All,
I am new here (First Post...) I did a search and found some useful stuff, but not quite my situation...
I have quite a few All-In-One Units that have been deployed throughout our customer base, they are all running Windows POS Ready 2009. These units have a 10% failure rate, and 5% of the time they can be fixed by a System Re-Image.
This is possible via Thumb Drive, boot from a formatted thumb drive with the MS-DOS Files, Ghost, and the Ghost image file and it is good to go from there.
However... I need to figure out a way to do this remotely? Such as, setup a partition on the SSD. The only problem is that I cannot seem to get MS-DOS to work on the partition... I have achieved this with Windows POS Ready 7, but not 2009...
Any suggestions?
Thanks so much!
I am new here (First Post...) I did a search and found some useful stuff, but not quite my situation...
I have quite a few All-In-One Units that have been deployed throughout our customer base, they are all running Windows POS Ready 2009. These units have a 10% failure rate, and 5% of the time they can be fixed by a System Re-Image.
This is possible via Thumb Drive, boot from a formatted thumb drive with the MS-DOS Files, Ghost, and the Ghost image file and it is good to go from there.
However... I need to figure out a way to do this remotely? Such as, setup a partition on the SSD. The only problem is that I cannot seem to get MS-DOS to work on the partition... I have achieved this with Windows POS Ready 7, but not 2009...
Any suggestions?
Thanks so much!
