RAM problems

[nubreed000]

I have a MSI K8T-F, with OCZ 256x2 Dual Channel Enhanced Latency RAM...

When I plug the RAM sticks into slots 1-3 OR 2-4...No signal goes to my monitor when I turn the computer on. When I try slots 1-2, only 1 RAM stick is recognized.

Anyone know what the problem is?

 

[imported_AndyT]

HI, I would clear your bios by unplugging your PSU and removing the battery on the board for about 30 seconds. Meke no BIOS changes and try the memory again and see what happens. On that board is it dual channel when running 1,3 or 2,4?

The next step woul be to raise the DDR voltage to 2.7v. Go into the BIOS with 1 module running. This may help.

Let me know what happens.

 

[nubreed000]

Hey, thanks for the reply.

I tried both and it didn't help.

The ONLY difference now is that I have both modules installed in slots 2 and 4 (dual channel combo) but when I go to System in Windows. it still only shows 256MB of RAM.

I copied down the RAM configuration; thought maybe that would be of some help, so here it is:

DRAM Clock mode: By SPD
Memclock value: DDR200
CAS Latency: SPD
Burst Length: 8 beat
Bank Interleaving: Auto
Active to CMD (Trcd): Spd
Active to Precharge: Spd
Precharge to Active: Spd
DRAM 1T Timing: DIsabled

Hope this gives you an idea