Quick question about MBM5 setup.

[GD695372]

I have an Abit KT7A, and have been unable to determine what sensors I should be using the readouts from(eg: winbond 1,2,...). Any and all help would be greatly appreciated.

 

[loup garou]

Under temperature, board sensors, assign VIA686A-1, VIA686A-2, VIA686-3 to Sensor 1, 2, and 3.

Didn't see that that was a KT7A, works like that with the original KT7, don't know if it will work with the A.

 

[Soybomb]

Best of luck, that thing has crashed so many of my boxes so many times...

 

[loup garou]

No sh!t Soybomb....and I really think it's just the newer versions. The older ones seemed much more stable.

 

[Soybomb]

Lol I dont know, the first time I had it was on a....I'm thining pentium 200 that I was overclockin' and it crashed it alot to....those damn little green bars for about 1/4" at the top of the screen, and its done the same thing to varying degrees to each computer since. Anymore I just run it for like an hour to see what the temp is then rely on the motherboard to beep or something if its too hot