Look in my sig for specs.
Iv been running my 2400+ at 2.4Ghz with 1.85 volts under full load for some time now and my temp is 91-93F.
Since im watercooling and my setup is outside in the 30-45F degree weather I was wondering if my cpu temp was really this high or if the sensor is off since my case temps is almost always 80F ?
When I touch the side of my waterblock its rather cold, the hoses are cold as well.
So do these temps seem about right for watercooling with water temps around 40F ?
Something else I was wondering, Im using a DangerDen Maze4 WB, copper heatcore with one 120mm fan. Im using at the most 20 feet of 3/8 hose to go from the WB outside and back. If I remember right, the pump Im using is rated at 210GPH, It might be 3XX GPH but I know fure its under 400. Is this enough for the setup I discribed or would it help getting a 500GPH+ pump?
Sorry if something doesnt make sense but Iv only had 4 hours of sleep in the last 28 hours.
Iv been running my 2400+ at 2.4Ghz with 1.85 volts under full load for some time now and my temp is 91-93F.
Since im watercooling and my setup is outside in the 30-45F degree weather I was wondering if my cpu temp was really this high or if the sensor is off since my case temps is almost always 80F ?
When I touch the side of my waterblock its rather cold, the hoses are cold as well.
So do these temps seem about right for watercooling with water temps around 40F ?
Something else I was wondering, Im using a DangerDen Maze4 WB, copper heatcore with one 120mm fan. Im using at the most 20 feet of 3/8 hose to go from the WB outside and back. If I remember right, the pump Im using is rated at 210GPH, It might be 3XX GPH but I know fure its under 400. Is this enough for the setup I discribed or would it help getting a 500GPH+ pump?
Sorry if something doesnt make sense but Iv only had 4 hours of sleep in the last 28 hours.
Facebook
Twitter