Problems with 566celeron

[badxcow]

i recently bought a celeron 566 fcpga and im using it with an abit be6. i have the newest bios installed and it runs perfectly at 566. however i want to overclock it to 100fsb (850mhz). the bios shows that the default voltage (under softmenu2) to be 1.7v. now i know this is wrong because the 566's are supposed to be at 1.5v. Could this be the cause of my slocket? Its a no-name brand slocket. After seeing this problem i purchased an abit slocket to go along with my be6, but it hasnt gotten here. So any help? Is it my slocket? I have pc100 generic ram...wat are my odds of gettin up to 850 or above? thanx everyone.

 

[MadRat]

I had to go through three noname slotkets before one finally posted mine at 850mHz. This was at 1.8 volts.

 

[ModMan]

The latest 566 (cC0 stepping) Celerons are 1.7 volt default voltage. Unless you have selected 1.7 volts on your slotket, you have a cC0 Celeron. Get the MS-6905 slotket, rev 2.x (Onvia has them). The Abit slotket is not highly rated.