problem with Abit BE6-2 and FCPGA

[Chintan]

Hi,

I'm having a problem putting together a new system. Here are the specs

Abit BE6-2 (newest revision w/ HPT3770 controller chip)
Cumine FCPGA 600E cB0
Iwill Slotket 2
PC133 128MB RAM
Diamond ViperII AGP Card
blah blah blah

the problem is that the motherboard won't post with thse components installed. I tried the slotket/cpu combination in an older Abit BE6-2 motherboard and it worked fine. I tried the RAM in the other mobo and it worked fine. I even tried using a different video card on the newer Abit board, and no post.

I took the mobo to the store, and the guy put an SECC2 Pentium II chip and some ram and whatever, and the board posted. so he said it worked and i had to take it back. Anybody have any ideas or experience with this setup? any help will be greatly appreciated.

thanks

 

[Steven the Leech]

did you set the voltage on the slotket? 1.65 or so i think and the fsb to 133/ or 100?

 

[Chintan]

voltage on slotket and everything are fine... i tried the slotket/cpu combo in another mobo and it worked.

 

[Nih]

are you posting it out of the case? is your power supply adequate? If all else fails try screaming at it. I have been doing alot of screaming at abit be6-2's lately , ( it works with 1 out of 3 btw) , try out of the case without kb plugged in. Or clear the cmos and try again. also i have noticed that those abit's are real picky about slotkets, perhaps try a different one to post.