stonecold3169
Platinum Member
Hey all. Until a few days back I had a 200fsb tbird unlocked with the pencil trick running on an Abit kt7a-RAID. This worked fine, all multipliers were available to use with any given fsb.
a few days back I switched to a Soyo Dragon Ultra Platnum kt333. I put the chip in, and it detected itself as it's normal 100fsb self, with a 14 multiplier. No problem I tell myself, I'll just switch to 133/10.5. No post. Okay, well, I must have ruined a connection when I applied the heatsink. I took it off, redrew the bridges, same deal. Getting ticked off now, I start going through the bios quickly, and somehow managed to set it to 100/6... and it posted. 7 and 7.5 multipliers won't boot. 8 will, occasionally. 133/10.5 posted correctly... ONCE. 100/14 will always work correctly, as does the 100/6.
Now, I thought unlocking was an all or nothing sort of deal... and even if it wasn't, why the heck would it post at the desired speed once but never again? I'm a confused boy... any words of advice?
a few days back I switched to a Soyo Dragon Ultra Platnum kt333. I put the chip in, and it detected itself as it's normal 100fsb self, with a 14 multiplier. No problem I tell myself, I'll just switch to 133/10.5. No post. Okay, well, I must have ruined a connection when I applied the heatsink. I took it off, redrew the bridges, same deal. Getting ticked off now, I start going through the bios quickly, and somehow managed to set it to 100/6... and it posted. 7 and 7.5 multipliers won't boot. 8 will, occasionally. 133/10.5 posted correctly... ONCE. 100/14 will always work correctly, as does the 100/6.
Now, I thought unlocking was an all or nothing sort of deal... and even if it wasn't, why the heck would it post at the desired speed once but never again? I'm a confused boy... any words of advice?
