Periodic BSOD and 10sec Orthos runs

[swu]

I recently updated my Foxconn C51XEM2AA board with some new parts. Went from 4600+ X2 to 6400+X2 and replaced my 2GB of Corsair XMS2 6400C4 with 4x1GB of Crucial Ballistix DDR2 6400. And a BFG 8800GT OC2.

CPU at stock. RAM at labeled timings and voltage of 4-4-4-12 2.2v

So i keep getting periodic BSOD. So I decided to run orthos to check cpu and memory stability, on average i get an error in 10 seconds. wtf. So I do the obvious thing and test each memory module in Memtest. 2-3 passes on each module and no errors. No errors even with all 4 modules in.

I really need help i did everything that usually to check for dead or damaged sticks but not sure since non of them produced any errors.

Also an another point i dont really think it is relavent but every once in a while on BSOD the 8800gt driver get corrupted and uninstalls itself.

 

[vanvock]

Have you checked temps? Is your psu up to the task? Full system specs would help folks help you. Welcome to AT, btw.

 

[swu]

Temps are normal for the parts - CPU idles at around 38C and Case Temps are around the same. I touched the ram modules and the heatspreaders arent really hot. GPU runs at mid 50C which is normal with stock cooling. And the PSU is definately up to the task, its a 750 Thermaltake Toughpower.

Here are the specs-
AMD 6400+ X2 BE - Stock 3.2Ghz
4x1GB Crucial Ballistix DDR2 800 6400 - Stock rated 4-4-4-12 at 2T timing at 2.2v
Foxconn C51XEM2AA Mobo
2x200GB Western Digital SE
BFG 8800GT OC2
Thermaltake Toughpower 750 Watts
I dont remember off hand the Lian Li model but its a full tower and i have pretty good wire management
And a 2 optical Drives