PC won't Boot

[kangkongkernits]

Last nyt after installing a new HSF my pc wont boot,case fans are spinning,Heat sink fan is spinning but no boot up. What made things worst there is no beep at all. i have a abit ip35-e mobo and some should know of the double boot issue,but mine does not even pass the double boot. any suggestions on what to do? thanks

 

[MagnusTheBrewer]

Du u hef ani dsplay? Sorry, I couldn't resist. Did you clean and re-apply a thermal compound to your CPU? Did you re-seat the CPU? Did you check ram and GPU are seated correctly?

 

[robisbell]

when you applied the thermal transfer compound, you only put a dab on the processor, correct?
I agreee, make sure the CPU,GPU, and ram are seated snugly.

make sure your 20(24), 4, and power connectrs for the motherboard and video card are connected.

 

[kangkongkernits]

all i did was remove the previous hsf and put in the new one,ram and gpu are seated correctly,will try tonight sir. only had an hour of sleep because of this

 

[kangkongkernits]

if i forgot to put the 4 power connectors and turned on the pc will it damage either my board or processor?

 

[mechBgon]

Originally posted by: kangkongkernits
if i forgot to put the 4 power connectors and turned on the pc will it damage either my board or processor?

Not usually.

 

[robisbell]

it's a posibility, but did you clean off the old compound off the processor before applying nw compound and installing the HSF?

 

[kangkongkernits]

@mechbgon
hope not cause i remember not putting the four pins and turned it on. Then i i connected it again,same result.

@robisbell

yup,cleaned the hsf and procie and replaced the compound. whew,im installed a Ttake Big thypoon,quite hard installing it and tightening it. Whats better, a tight installation of HSF or loose?

 

[robisbell]

tight, but not to tight or you can snap something

 

[kangkongkernits]

problem solved.. looks like i got a faulty fan from my hsf, replaced it and worked A-OK now thanks all for your help