Hey guys,
Just installed my 1.6a and P4S333 and have it oc'd to 120 fsb at the moment. Is there a turbo 1 setting on this board? I have looked every where, but see nothing that says as such. I see a 1 T under a memory setting, but that is it. I want to be sure I am not overclocking my PCI/AGP. Also, I have an enermax case (Antec 1040 look alike) with a 330 w psu. It has a small 3 pronged connector comming out of the psu, I plugged that into the mobo's fanpwr connector, but when I turn my comp on, it gives a boot up error about the hardware monitor. So I go look and it says the fan is running at 1660 rpms and is shaded red. Is this a problem? Comments are appreciated.
Thanks much
My Rig
P4 1.6a@1920mhz
Asus P4S333
512mb PC2100 Corsair
Enermax FS-710 w/ 330W psu
GeForce 2 GTS 32mb
Just installed my 1.6a and P4S333 and have it oc'd to 120 fsb at the moment. Is there a turbo 1 setting on this board? I have looked every where, but see nothing that says as such. I see a 1 T under a memory setting, but that is it. I want to be sure I am not overclocking my PCI/AGP. Also, I have an enermax case (Antec 1040 look alike) with a 330 w psu. It has a small 3 pronged connector comming out of the psu, I plugged that into the mobo's fanpwr connector, but when I turn my comp on, it gives a boot up error about the hardware monitor. So I go look and it says the fan is running at 1660 rpms and is shaded red. Is this a problem? Comments are appreciated.
Thanks much
My Rig
P4 1.6a@1920mhz
Asus P4S333
512mb PC2100 Corsair
Enermax FS-710 w/ 330W psu
GeForce 2 GTS 32mb
Facebook
Twitter