I've overclocked my ASUS P3B-F board w/ a 500 Mhz P3 to 575 Mhz with no problems, after adding a new HSF. My next setting on my FSB is 120.0/40.0 Mhz (system/PCI). When I move it to this setting, everything posts just fine, but locks up @ Win2K startup. I'm pretty sure this is due to my hard drive on a ATA/66 IDE card not liking the higher PCI speed.
When I move the setting to 133/33, all I get is a flashing cursor at the top of the screen, so I don't think my processor can handle this speed. Any suggestions as to get my processor/PCI cards running at a faster speed? I've tried WCPUID to adjust my L2 latency, but it just locks up my computer when I try to change it.
Any suggestions?
When I move the setting to 133/33, all I get is a flashing cursor at the top of the screen, so I don't think my processor can handle this speed. Any suggestions as to get my processor/PCI cards running at a faster speed? I've tried WCPUID to adjust my L2 latency, but it just locks up my computer when I try to change it.
Any suggestions?
Facebook
Twitter