I've got the Iwill KA266-R rev 1.3 w/ BIOS v2/15/01. Running an AMD 1133/133FSB processer.
I believe I've successfully closed the L1 bridges (done it three times now!) but when I change the multiplier settings on the mother board to anything but auto it won't boot. I get the post beep, but no monitor signal. It just sits there. I can overclock in the BIOS uping the FSB to 146/146, and vcore to 1.85 to get 1250, but I want the Multiplier too! Any way to tell if I haven't successfully crossed the L1's or if it's the MB? I thought that the system should still boot at whatever the multiplier is set at even if the L1's aren't crossed!
HELP?
SUGGESTIONS?
Thanks
I believe I've successfully closed the L1 bridges (done it three times now!) but when I change the multiplier settings on the mother board to anything but auto it won't boot. I get the post beep, but no monitor signal. It just sits there. I can overclock in the BIOS uping the FSB to 146/146, and vcore to 1.85 to get 1250, but I want the Multiplier too! Any way to tell if I haven't successfully crossed the L1's or if it's the MB? I thought that the system should still boot at whatever the multiplier is set at even if the L1's aren't crossed!
HELP?
SUGGESTIONS?
Thanks
Facebook
Twitter