Overclocking E7500

[hot120]

I just overclocked my E7500 to 3.67ghz stable running Orthos for 6 hours. My specs are below. Is there anything I can do get it higher? I was actually able to get to 3.9ghz, but Windows 7 was reporting in System Performance Settings that I was only running @ 3.67. CPU-Z and EasyTune was reporting the correct O.C. Orthos was reporting both 3.67 and 3.9. Can anyone suggest some tweaks to make the system tighter? Thanks for any help!

CPU VCore: 1.34
3.67 @ 333.3 Bus Speed with a 11.0 Multiplier
CPU Temp: 30-35 C (Idle), 55-60 C (Load)
1:1 FSB/DRAM @ 333.3 MHz
5-5-5-15 Timings

 

[BushLin]

Usual stuff I guess. Find the upper limits of your current setup... after finding the top FSB, lower RAM latencies, enable performance options in BIOS and test. Further than that, get better cooling and clock it higher, you could throw in a better chip. I'd check overclocking forums/faqs/guides on your particular board... I found I could get a 7.5 multiplier from an e8200 (default 8x) on a DFI board by loading a quad core profile to get 533x7.5 rather than 500x8 at the low voltages I wanted.

 

[Slavik19]

I just overclocked my E7500 to 3.67ghz stable running Orthos for 6 hours. My specs are below. Is there anything I can do get it higher? I was actually able to get to 3.9ghz, but Windows 7 was reporting in System Performance Settings that I was only running @ 3.67. CPU-Z and EasyTune was reporting the correct O.C. Orthos was reporting both 3.67 and 3.9. Can anyone suggest some tweaks to make the system tighter? Thanks for any help!

CPU VCore: 1.34
3.67 @ 333.3 Bus Speed with a 11.0 Multiplier
CPU Temp: 30-35 C (Idle), 55-60 C (Load)
1:1 FSB/DRAM @ 333.3 MHz
5-5-5-15 Timings

>
>
>
>
>
Try to make your Vcore 1.296 and then bus speed to 500 and multiplier to 8 and i gues you will get to 4000.0Mhz or 4GHz