Overclocking Celeron 466

[gtfc113]

i have a celeron 466. currently its o/c @525 at default voltage which is 2.1v.....my question is how could i get it to overclock higher? the celeron's clock is locked at 7.0 and right now i have the fsb at 76 which is one of my mobo's only 3 settings....(66/76/83)
i have good cooling in my opinion....with my current config. the temp is around 26C when idle. i dont know much about the voltage's effect on o/c'ing but when i dont do anything to it, and set my mobo to 83fsb, i get an error during bootup that says my ntoskrnl.exe is missing. whats that all about? it isnt missing....

anyway, any help would be appreciated.

 

[jsbush]

That's pretty much the limit for the 466. They don't overclock that high.

 

[Blayze]

I have a Celeron 466 in one of my systems as well. The highest I could get it to was 525mhz.
Its currently running at 466mhz. Parents use it for word processing, internet, etc...

 

[gtfc113]

thanks guys....in that case, whats the next step up that is CHEAP and still pretty overclockable? when i say cheap...i mean cheap...im 16 and BROKE...i have $10 in my pocket right now....my mobo has a slot 1 and socked 370 but id prefer the socket since i already have an hsf for it....

thanks again

 

[bhess]

I would try raising your voltage. My cel 466 ran at 581. I've gone higher but the pci bus was low above 83 mhz.

 

[Wuming]

i think your cpu should be able to do 7*83 mhz. my C400 did 6*95 mhz okay. up your voltage slightly. getting a new mobo would, of course, be the best option!

 

[Stang289]

Look on your mobo and see if there is a Async jumper. This jumper allows the FSB to run at 83MHz without overclocking the PCI bus.

 

[Rhonda85]

Is there a 76 mhz bus speed?