I notice that on the SCANSOFT web site OmniPage 10, OmniForm 4 show the MicroTek E6 as being fully supported.
HOWEVER, if you look up OmniPage Pro version 11, it only shows 2 Microtek scanners as being supported.
Anyone know if the new OmniPage Pro 11 has stuff that will no longer work with the E6 or is the web page, perhaps, not updated?
TIA
HOWEVER, if you look up OmniPage Pro version 11, it only shows 2 Microtek scanners as being supported.
Anyone know if the new OmniPage Pro 11 has stuff that will no longer work with the E6 or is the web page, perhaps, not updated?
TIA
Facebook
Twitter