j/k i needed your attention because no one was replying to my previous post.
my actual question: For my Tbird 800 i switched from a golden orb to a taisol (non copper) w/ AS grease. my temps idle now are between 38-39C, full load it only reads 2C higher. In the bios its pretty much the same. my mainboard temp is 27C but thats beside the point. I was only able to place the thermal sensor in so far, almost halfway to edge of the core or less. would that make much of a differenence? i want to make sure i have an accurate reading before i overclock.
my actual question: For my Tbird 800 i switched from a golden orb to a taisol (non copper) w/ AS grease. my temps idle now are between 38-39C, full load it only reads 2C higher. In the bios its pretty much the same. my mainboard temp is 27C but thats beside the point. I was only able to place the thermal sensor in so far, almost halfway to edge of the core or less. would that make much of a differenence? i want to make sure i have an accurate reading before i overclock.
